Properties

 

You can see the following dialog box. To understand the meaning of each parameter, refer to Figure 2 and Table 1.

 

Figure 1  Ball Bearing property page [Group Ball Bearing Geometry page]

 

     Bearing Thickness: Enters the thickness of the bearing.

     Inner Ring

    Outside Diameter: Enters the outside diameter of inner ring.

    Inside Diameter: Enters the inside diameter of inner ring.

    Rolling Line Diameter: Enters the rolling line diameter of inner ring.

    Groove Diameter: Enters the groove diameter of inner ring.

     Outer Ring

    Outside Diameter: Enters the outside diameter of outer ring.

    Inside Diameter: Enters the inside diameter of outer ring.

    Rolling Line Diameter: Enters the rolling line diameter of outer ring.

    Groove Diameter: Enters the groove diameter of outer ring.

    Number of Segments: Enters the number of segments. This can be defined when create a bearing.

     Ball

    Number of Balls: Enters the number of balls. This can be defined when create a bearing.

    Ball Diameter: Enters the diameter of ball.