Properties

The properties dialog box of the Arc Guide has three tabs.

Figure 1  Guide Arc property page

•     Guide Mother Body: Selects the mother body of Arc Guide by clicking B.

•     Radius: Defines the radius of Arc Guide.

•     Angle: Defines the angle of Arc Guide.

•     Center Point: Defines the center point of Arc Guide.

•     Direction to Start Point: Defines the direction to the start point of Arc Guide.

•     Imaginary PEdge: Defines an imaginary PEdge on start and/or end point of Arc Guide. The imaginary PEdge is a circle shape and located start/end point. And the center point of imaginary PEdge is located negative direction of contact (normal) direction. User can see the imaginary PEdge by clicking Preview.

•    Edge: Defines Enable(Checked) or Disable(Unchecked) on the Start and/or End point.

•    Raidus: Defines a radius of the imaginary PEdge. The user can set a connection with SPV value.

•     Contact Direction: Allows seeing the direction of contact with the sheet on the arc guide by clicking Preview. If the direction is not correct the user can switch between Up and Down.

•     Contact Parameter: Allows the user to modify contact parameters by clicking To Sheet. In this dialog box, the user can modify the contact parameters of contact forces applied between the sheet and the guide. Refer to the Contact Formulus for MTT2D.

Figure 2  Contact Parameter dialog box

•     No. of Max Contact Points: Defines the number of max contact point for output. User can define this value from 1 to 5000. This value only affects Force Display and RPLT data about the contact points. The default value is 10.

•     Force Display: Graphically displays the all contact force vectors (the sum of the normal and tangential contact force) at each contact point up to the “No. of Max Contact Point”.