The Transfer Function block implements a transfer function.
The system is defined by
where, NUM (·) are the coefficients of the numerator, DEN (·) are the coefficients of the denominator, NNUM and NDEN are the numbers of numerator and denominator coefficients.
Dialog box
Figure 1 Transfer Function dialog box
Parameters
|
Parameter(s) |
Description |
|
Numerator |
Enter the coefficients of the numerator in descending powers of s. If Numerator is a matrix with multiple rows, the block outputs the multiple output signals. |
|
Denominator |
Enter the coefficients of the denominator in descending powers of s. |
|
Abs tolerance |
Enter the value for the Absolute tolerance. •If the Abs tolerance is inputted as -1, the value defined in the Simulation Parameter dialog box is used. •If the Abs tolerance is inputted as a value, this value is used instead of the value defined in the Simulation Parameter dialog box. |