Figure 1 V Pulley property page [Characteristic page]
The V Pulley property page is shown in Figure 1. The parameters are explained below. In order to understand the geometry, refer to Dimension Information.
•Inner Radius (Ri): Enters the inner radius of V pulley. The inner radius is larger than 0.
•Radius (R): Enters the radius of V pulley. The radius is larger than Ri.
•Outer Radius (Ro): Enters the outer radius of V pulley. The outer radius is larger than R.
•Width (W): Enters the width of V pulley. The width is larger than 0.
•Pulley Width (Wp): Enters the pulley width of V pulley. The pulley width is larger than W.
•Angle (A): Enters the angle of V pulley. The angle is larger than 0 and smaller 2*atan (W/(2*(R-Ri))). The bottom width of V pulley is W-2*(R-Ri)*tan (A/2). [Degree]
•Assembled Radius: Enter the assembled radius of roller. The radius is larger than 0.
•Full Search: If this is checked, all belt bodies are searched for the contact with the V pulley.
•Partial Search: If this is checked, belt bodies within the given bounds are searched for the contact with the V pulley.
•User Boundary: Enter the range of boundary.