Figure 1 Roller property page [Characteristic page]
The Roller property page is shown in Figure 1. The parameters are explained below. In order to understand the geometry, refer to Dimension Information.
•Radius (R): Enters the radius of roller. The radius is larger than 0.
•Width (W): Enters the width of roller. The width is larger than 0.
•Assembled Radius: Enter the assembled radius of roller. The radius is larger than 0.
•Full search: If this is checked, all belt bodies are searched for the contact with the roller.
•Partial search: If this is checked, belt bodies within the given boundary are searched for the contact with roller.
•User boundary: Enters the range of boundary.