Figure 1 VBelt property page [Characteristic page]
The VBelt property page is shown in Figure 1. The parameters are explained below. In order to understand the geometry, refer to Dimension Information.
•Height (H): Enters the height of V-belt. The height is larger than 0.
•Thickness (Ht): Enters the belt thickness of V-belt. The belt thickness is larger than H.
•Width (W): Enters the width of V-belt. The width is larger than 0.
•Angle (A): Enters the angle of V-belt. The angle is larger than 0. The angel is smaller 2*atan (W/(2*H)). The bottom width of V-belt is W-2*H*tan (A/2). [Degree]
•Segment Length (L): Enters the length of V-belt. The length is larger than 0.
•Cord Distance (a): Enters the cord distance of V-belt.
•Left Connecting Position: Enters the left position of connecting force. The reference frame of position is the geometry reference frame of belt
•Right Connecting Position: Enters the right base position of connecting force. The reference frame of position is the geometry reference frame of belt.