The user can imprint edges on one geometric entity by offsetting some edges by the following procedure.
•Solid(Sheet), MultiEdge
•Solid(Sheet): Selects a solid or surface geometry to imprint.
•MultiEdge: Select some edges to offset. Imprint Offset Edges dialog box is shown. The imprint curves are created by clicking OK in the Imprint Offset Edges dialog box.
Figure 1 Imprint Offset Edges dialog box
o Entity Name: Shows the name of the selected entity.
o Offset Distance: The distance to offset the selected edges.
o Reverse Direction: Change the initial direction of the offset edges.
o Add/Remove: Selects several edges of the selected entity as the user wants to add or remove.
o Add/Remove (Continuous): When an edge is selected, all of the connected edges within the user-defined tolerance angle are selected at the same time.
o Preview: Preview of the offset edges on Working Window.
o Update: Updates the preview.