Figure 1 IMG & HYB & TRK
Type |
Parameters |
Integrator command | ||
IMG(IMGALPHA) |
Maximum Stepsize |
Error Tolerance |
Numerical Damping |
INT/IMG, HMAX=0.01, ERR=0.005, NDA=0.8 |
TRK |
Maximum Stepsize |
Error Tolerance |
Numerical Damping |
INT/TRK, HMAX=0.01, ERR=0.005, NDA=1.0 |
HYB(HYBRID) |
Maximum Stepsize |
Error Tolerance |
Numerical Damping |
INT/HYB, HMAX=0.01, ERR=0.005, NDA = 1.0 |
ADV(ADVANCED) |
Maximum Stepsize |
Error Tolerance |
Numerical Damping |
INT/ADV, HMAX=0.01, ERR=0.005, NDA = 1.0 |
• Refer to Dynamic/Kinemetic
Note
You must define the Integrator command prior to the Simulation command.
During the Simulation, the user cannot change the integrator type.