The Integrator block outputs the integral of the input signal at the current simulation time step. CoLink uses a number of different numerical integration methods to compute
The user can select a numerical integration method in the Simulation Parameter Menu.
Dialog box
Figure 1 Integrator dialog box
Parameters
|
Parameter(s) |
Description |
|
Initial condition |
If Initial condition source parameter is set to internal, the block gets the initial conditions from this parameter. |
|
Abs tolerance |
Enter the value for the Absolute tolerance. •If the Abs tolerance is inputted as -1, the value defined in the Simulation Parameter dialog box is used. •If the Abs tolerance is inputted as a value, this value is used instead of the value defined in the Simulation Parameter dialog box. |