Converting Clone Link Body into General Body

To create FaceSurface in the clone link body

Create a FaceSurface on the face where you want to create a Contact. Since you can also create a Contact on the face, create only one FaceSurface.

1.  Enter the Belt Subsystem Edit Mode.

2.  Use the following method to enter the Edit mode of the FlatBeltClone1 body.

•     In Database, right-click FlatBeltClone1.

•     When a pop-up menu appears, click Edit.

3.  On the Geometry tab, in the Surface group, click Face.

4.  Set the Creation Method to Face.

5.  Enter FlatBelt1.Face2 on the input bar.

6.  Right-click on the working window and click Exit to exit the Edit mode.

To convert the clone link body:

Convert the clone link of the open belt model to
General using the ProcessNet functions you have written so far.

1.  On the Customize tab, in the Convert group, click ChangeBody.

2.  Uncheck 2D system.

3.  In the ChangeGeneralBody dialog window that opens, select Belt Assembly1 and click the ChangeBody button.

4.  You can see that the clone link body has been converted into a general body as shown in the following figure.

5.  In the Database window, you can see that Body_Belt1_BeltAssembly1 and Connector_Belt1_BeltAssembly1 have been created. Select each group to see the result of creation.

To create a Contact:

1.  On the Professional tab, in the Contact group, click GeoSur.

2.  Change the Creation Method to Surface(PatchSet), Surface(PatchSet).

3.  Create a Geo Surface Contact by typing the values in the table shown below.

4.  On the Customize tab, in the Convert group, click CreateContact.

5.  The first text box is the link group body and the second text box is the contact. You can also drag and drop from the data base.

6.  Click the add button.

7.  Make sure that the created Contact is checked and click the Create Contact button.

8.  Confirm that the Contact has been created.