Align Guide Contact Direction And Imainary PEdge

This tool is useful to control contact direction and Imaginary PEdge of created all arc and linear guides at once without opening each Guide property page.

Figure 1  Align icon of the Guide group in the MTT2D tab

Figure 2  Align Guide Orientation

Step to Use

1.  Click the Align icon of the Guide group in the MTT2D tab. Then Align Guide Contact Direction And Imaginary PEdge dialog box appears.

Figure 3  Align Guide Contact Direction And Imaginary PEdge dialog box

2.  Select the desired contact direction at view or this dialog.

3.  Additionally, if you want to use imaginary pedge guides on a start or end point of the guide, select PEdge Start or PEdge End.

4.  Confirm the operation by clicking OK.